Gas can holder

[bat]

The guy across the street has been teaching me how to weld so I thought I would build my own swing away gas can hoders.

21685


21686


21687


21688

[theMec]

Very Nice! Welds look good too.
Could you say a bit more about the pivot mechanism. Thanks!

[bat]

It is a spindle and bearing setup from a trailer place and the casing around the bearing was machined and bought of the internet. I was trying to figure how I could keep the stock bumper and still carry gas and be strong. There is a bracket that comes off the frame to the 1/4 steel plate so not all the support is on the bumper.

[02TahoeMD]

Hey, nicely done! Like, that should be in a Ford parts catalog. I tried doing something similar for my first go at having a spare tire carrier, I had to brace the underside of the bumper BIG TIME to give it enough strength....but a factory bumper should be able to handle the weight of a loaded jerry can just fine.

Well done! Jealous you are learning welding.

[kcowyo]

That's great, I really like that.

Nice work - :beer:

[Momrocks]

Great concept! Nicely done.