Rear Drawer update

[bluedog]

It's been almost 2 weeks but today I had a good 3.5 hrs. to spend on my rear drawer set up and made some good progress. My 36" slides arrived so I was able to get to the meat of the unit, the actual drawer and a hinged lid for the front section. My goal is to have it all buttoned up by next Thursday.


http://img.photobucket.com/albums/v462/bikewrench/drawerphaseII1Small.jpg

http://img.photobucket.com/albums/v462/bikewrench/drawerphaseII2Small.jpg

I decided to do a double hinge lid (I only have one done) for easier access from the rear passenger door. I figure this will be a great place for an inverter.
http://img.photobucket.com/albums/v462/bikewrench/drwaerphaseII3Small.jpg

[upcruiser]

Cool. Are you leaving the left-hand side open? I'm trying to figue out a plan of attack for my new setup I want to build. I'd like to be able to stash a couple of bikes inside the truck if needed and therefore want to keep an open area where I can stand them up with the front wheel off. I need to have enough width though still to sleep two people. Are you planning on carpeting it or painting it when done?

[Willman]

I like it!!!!!

Thanks for the update!!!!

:D

[bluedog]

The left side will be open for my bike. the right is the drawer and sleeping platform. I will carpet the entire thing and bolt it down to a few of the seat mounting holes.


This is the first thread I started on my project. It should give some prespective on how it will be used.
http://expeditionportal.com/forum/showthread.php?t=5389


B.