Search:

When mounting the tire, what keeps the pivot pins to the side and out of the way?

When reaching through the inner bead, is the safety bead on the inside of the wheel smaller or shallower to gain...

Jim, i feel for you man!!

These batteries are not what they used to be...

common words when shopping for this sort of stuff..

solenoid-simple, dumb, same as a starter solenoid(not really, but to keep it simple)
separator-smart solenoid, moving parts
isolator-smart, no...

don't bother with lockers.

**Not hating on your rig, at all!!!*** A liberty is not a good vehicle for building like that. you just have to replace everything to get halfway to what a stock...

I am planning to spray a project i am building right now. I did some research on the rustoleum and played around with some colors and clear.

when i sprayed just the color, it looked ok. lots of...

the rear driveshaft length isnt an issue with the 5 speed and split case.

the TSM e brake option works well, but doesnt fit well. to fit it under the 40, you have to mount it low on the transfer...

sure looks like a pain to replace that fuse!!


Ha ha........sweet ride!!

P.S. i've got a full size van now, aka the "free candy" van

when i did a dual battery setup on a 200, i ended up putting the second battery behind the ARB bumper. I had to make a custom bracket and the location is not ideal(especially if you don't have a...

Not that this hasn't been argued over and over, but don't we buy Toyota Land Cruisers for a reason?

How many miles did the stock hose last? Usually at least 150K. I have replaced stock ones with...

make sure your timing is right. i mean make sure all the marks are aligned properly on the cams and crank.

otherwise look into exhaust restriction.

if these are anything like all the other Icon stuff i have installed, they will be very well made and ride great!

most likely the wheel bearings were real loose.

that is exactly what i was suggesting. Looks great!

look forward to seeing more of the build!

All looks like great work!!!!

keep an eye on the rear upper link mount at the frame. after doing a similar 3 link on the rear of a 4th gen 4 runner, the frame does not hold up to abuse very well....

Very nice rig!!

Always a pleasure to see/work on it!

keep it stock and the MPG's are tolerable.

80 series is a great cruiser, just get a 93 or newer.

if you can afford a 100 series go for it!

I have done alot of the PHH replacements and although silicone sounds nice, it does like to leak unless you use the constant tension clamps(which are bulky)

Alot like Klierslc said if the original...

i have seen the booster to firewall seal cause some wet carpet before. might be worth checking as well.

the windshield seal leak is very common.

Scat procar elite seats are very comfortable and they fit in alot of vehicles

sure is purdy!!

always put the winch on the main battery. the winch does not need to run off of two batteries. it is always a good idea in older vehicles or any thing with an upgraded alternator to run a heavy gauge...

starter draw becomes much larger when it is cold outside. something that alot of people forget to consider when finding fuses/breakers.

when they went with the 5 speed the engine got a bit more power as well.

the 5 speed requires fancy fluid and has no dip stick.


i would go for the 03-04 and up for the nicer interior and...

fast click? mean lots of clicking?= battery voltage or connection problem.

just a single click when key is turned? = prob over tightened the pos battery post on the generic starter that they...

you should stop by Iron Pig Offroad sometime if you haven't already.

also if you need technical assistance on anything landcruiser, we can help.