Search:

Type: Posts; User: mike5

Page 1 of 6 1 2 3 4

Search: Search took 0.04 seconds.

  1. It's most likely your alternator.

    It's most likely your alternator.
  2. Replies
    6
    Views
    350

    Thanks for that. Well the cleaning did not fix...

    Thanks for that. Well the cleaning did not fix it. Today is a hot day in SoCal. Started the car, drove 10 minutes to someones house, parked for 30 min. Came to start the car and it sounded a...
  3. Replies
    6
    Views
    350

    Thanks for the info. I crawled down there this...

    Thanks for the info. I crawled down there this morning and had a look. Looks like two bolts holding the starter/solenoid and on the solenoid 3 connectors. My guess is power, ground and a sensor...
  4. Replies
    6
    Views
    350

    1996 montero SR 3.5

    1996 montero SR 3.5
  5. Replies
    6
    Views
    350

    Need info on removing the starter

    I think it's time to rebuild the starter. I looked at the FSM but I have a couple of questions as it's not clear to me. First, where is the starter and how do I get to it. Is it from the bottom on...
  6. I temporarily fixed it too. Unfortunately it...

    I temporarily fixed it too. Unfortunately it didn't last long.
  7. I know they show having it, but it's...

    I know they show having it, but it's discontinued. Try ordering from them, your order will be cancelled:-)
  8. I'd be happy to pay postage. Just PM me and we'll...

    I'd be happy to pay postage. Just PM me and we'll go from there.

    They don't make these parts anymore so can't find it at any dealer.
  9. Replies
    83
    Views
    16,947

    It's been a little while but I have a couple of...

    It's been a little while but I have a couple of updates. About a month ago I hit 200k. It's been a pretty good truck so far.

    I also added a couple of lights that I think will be perfect for...
  10. Replies
    83
    Views
    16,947

    Clem, My issue, like that of many others, is...

    Clem,

    My issue, like that of many others, is that when unlocking with the interior buttons it would immediately lock again. This was also the case when using the key on the passenger side....
  11. Replies
    83
    Views
    16,947

    Another victory. Went to a local dismantler today...

    Another victory. Went to a local dismantler today and got a door lock actuator. Swapped it out in 30 min total. Now when I unlock the doors they don't automatically lock again! Now I even using the...
  12. Replies
    0
    Views
    241

    Trans Temp Gauge Install in GenII?

    I'd like to monitor the trans oil temp in my 96 SR. But I can't seem to find any info. General ideas include using a T fitting to tap into the existing one (for AT light) sensor. Anyone have any...
  13. Replies
    83
    Views
    16,947

    Couple of more updates. First for an addition. ...

    Couple of more updates. First for an addition. I added the overhead grab handle to the front driver's side. From the factory the holes are there but no handle. I bought a handle from the junk yard...
  14. Replies
    83
    Views
    16,947

    Clem, My overall impression of the KOs was...

    Clem,

    My overall impression of the KOs was that they were ok. Let me explain. For highway and city roads with snow and moisture...no problem. For the dirt trails with fresh powder...problem. ...
  15. Replies
    83
    Views
    16,947

    Well, I have a few more updates: 1. Removed...

    Well, I have a few more updates:

    1. Removed front sway bar a few weeks ago. You can definitely feel the car sway, but if you drive within those parameters you're fine.
    2. Added Trail Gear rock...
  16. Found a Mitsubishi dismantler in Sun Valley (So Cal) with lots of Monteros

    I live relatively close to Sun Valley, and there are a bunch of dismantlers along with pick and pull parts places. But most don't have anything Mitsubishi. I found this out today while I was...
  17. Replies
    83
    Views
    16,947

    Got a few updates. 1. Removed the rear sway...

    Got a few updates.

    1. Removed the rear sway bar. You don't have to cut it. We had the car on a lift, removed one shock (while supporting the diff), removed all bolts holding the sway bar, and...
  18. Replies
    15
    Views
    1,109

    Update: I have replaced the antenna mast and...

    Update:

    I have replaced the antenna mast and I'm good to go! Got the part from http://www.antennamastsrus.com/. The plastic base required a little sanding to get it to fit...but afterwards it...
  19. Here is the part number I believe: MR219598 ...

    Here is the part number I believe: MR219598

    Anyone have an idea of where to get a new one or a OE manufactured one?
  20. I think you need to remove the front bolts, then...

    I think you need to remove the front bolts, then fold the front up so it rests on the back side. Then you can see what else you need to remove to get the seat out.

    Btw: I confirmed with the...
  21. Middle row seat release cable broken, what part do I need?

    There is a cable that runs from the seat back to the seat bottom which releases the inside latch for the purposes of folding the entire seat forward (when needing maximum cargo space). This cable...
  22. Replies
    15
    Views
    1,109

    Off Roader: the install was painless. There is a...

    Off Roader: the install was painless. There is a window that shows up during the install which tells you which options to select.

    Inyo Man: I had to dig into the wheel well to 1) connect power...
  23. Replies
    15
    Views
    1,109

    Off Roader, The dealers finally pissed me off...

    Off Roader,

    The dealers finally pissed me off enough and I got ASA loaded up. Took 5 min but I think I got my answer: MB406894

    Off to the dealer tomorrow and hopefully buy a few clips.

    With...
  24. Replies
    15
    Views
    1,109

    Hi James, Thanks for the info. I've never...

    Hi James,

    Thanks for the info. I've never seen that button. But I did figure out a few things.

    In my case, someone had unplugged the wiring harness from the antenna motor so it would not keep...
  25. Replies
    15
    Views
    1,109

    How to tell if broken attend is powered?

    I've decided to fix my broken antenna. The actual mast is broken with nothing obvious in the hole. Apparently there are different antenna options on the Montero. I looked in the owners manual for a...
Results 1 to 25 of 149
Page 1 of 6 1 2 3 4