Search:

Type: Posts; User: pods8

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. No idea what is on the market, I just know I'd...

    No idea what is on the market, I just know I'd look long/hard for them and know what kind of value they'd hold to me personally with hindsight. If I didn't need to spend the hours I needed to making...
  2. Find some panels, trust me. :p No its a few...

    Find some panels, trust me. :p

    No its a few inches higher than the stock bed (I want to say 3-4" off my head but don't recall the stock bed height anymore, I think it was earlier in the...
  3. Moving to a new place, had to make up the jack...

    Moving to a new place, had to make up the jack brackets. Got to see what this looked like on the truck, SOMEDAY...
    ...
  4. Been on an extendo break, reality of 3 little...

    Been on an extendo break, reality of 3 little kids set in once #3 cleared the mostly all sleeping stage (along with still trying to pursue some other things in life). Life is calming down again,...
  5. Replies
    176
    Views
    39,102

    So our new base slides and swivels? That's...

    So our new base slides and swivels? That's pretty cool if so.
  6. Replies
    168
    Views
    31,480

    Naw, I have you beat. :p

    Naw, I have you beat. :p
  7. Replies
    627
    Views
    211,666

    The relay board with a main bus is pretty cool of...

    The relay board with a main bus is pretty cool of dispersing power in the back yet having low amp switches elsewhere.
  8. I was looking around some on astro stuff and as...

    I was looking around some on astro stuff and as long as you were using stock stuff I didn't think it sounded too bad for anyone that is comfortable pulling the subframe out from under a vehicle. ...
  9. Replies
    60
    Views
    26,647

    Like I said predictable. ;) you have control...

    Like I said predictable. ;) you have control over temp to avoid. I have two speeds of epoxy hardener specifically to deal with high and low temps, know your product and when to use/not use.
  10. Replies
    60
    Views
    26,647

    Two part products are nice for predictable curing.

    Two part products are nice for predictable curing.
  11. Replies
    7
    Views
    687

    It's just two wires, a basic single pole switch...

    It's just two wires, a basic single pole switch is fine. I installed one in parallel to the thermostat on my old camper.
  12. I was thinking perimeter snaps/Velcro/magnets...

    I was thinking perimeter snaps/Velcro/magnets around the outer door for putting up a screen material. Concern with the lower door would be having that open and then opening the big door would bang...
  13. Replies
    25
    Views
    6,136

    Epoxy isn't UV stable, it will chalk and degrade...

    Epoxy isn't UV stable, it will chalk and degrade over time when exposed to UV. IF you want to try something like this you'd need to use a UV varnish over top that would likely require periodic...
  14. Slowly still chipping away, life, newborn (and...

    Slowly still chipping away, life, newborn (and the other two young ones), the heat, and an issue with a neighbor (so I try to avoid power tool late or long, unfortunately later works better on the...
  15. Replies
    23
    Views
    4,986

    Would a high top, extended body E350 with a 4x4...

    Would a high top, extended body E350 with a 4x4 conversion if you enough footprint? You can find high top vans for a reasonable cost, then send for a 4x4 conversion (or do it yourself but you're on...
  16. Unless you need the short wheel base I'd think a...

    Unless you need the short wheel base I'd think a 4x4 conversion on a van would be the ticket. Some folks do flip up beds and even haul bike(s) internally.
  17. Replies
    1,630
    Views
    639,725

    Here ya go: http://www.aluminess.com/trucks.htm

    Here ya go: http://www.aluminess.com/trucks.htm
  18. A bit more per watt that some other offerings but...

    A bit more per watt that some other offerings but yeah that footprint is more compact for the wattage. What'd they hit you up for on shipping?
  19. Replies
    120
    Views
    23,932

    Well I'm doing a fiberglass build so it quickly...

    Well I'm doing a fiberglass build so it quickly comes to mind. :p I'm not familiar with the bonding profiles of rubber or aluminum over foam. I do know how to bond fiberglass on it so that's what I...
  20. Replies
    120
    Views
    23,932

    Are you handy? I'd take off the AC, side trip,...

    Are you handy? I'd take off the AC, side trip, etc. to give clear access to the roof. Peel off all the loose stuff (just like when repainting a house, take off the loose stuff) it all may come off...
  21. Replies
    340
    Views
    79,769

    Right on. I didn't have a second fan in my FWC...

    Right on. I didn't have a second fan in my FWC hawk and it didn't really bother me much. I added on in my build since it wasn't a big deal to do so and I think the ones I ordered can run w/ the lid...
  22. Replies
    25
    Views
    6,136

    Are you going to have an overlapping lip? If so...

    Are you going to have an overlapping lip? If so I may have something of interest, I bought a 100' roll of double bulb seal like below to put between my top and bottom half. However since it only...
  23. Replies
    25
    Views
    6,136

    Cool, go get'm! Did thayer have the 1582 glass...

    Cool, go get'm! Did thayer have the 1582 glass in stock when you ordered? I would have been tempted to try that out if they had it when I bought my glass. Pricing on it is sweet and as long as its...
  24. Replies
    340
    Views
    79,769

    Looks like your roof members are too narrow to...

    Looks like your roof members are too narrow to pop another fan between if you wanted to at this point? Otherwise I was going to say bracket/rivet in another piece to box an opening for on at a later...
  25. Replies
    189
    Views
    50,473

    Looking good. They do drag when you get over...

    Looking good.

    They do drag when you get over committed. :p
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4