JasonRedwood
Explorer
Hi there-
After a couple trips my Zodi hot shower is sputtering.
I have a trigger faucet modded to the hose. Everything worked great till the end of the last trip when the sputtering began.
I replaced a damaged o-ring that was located on the inside of the tank, and still had the sputtering.
I don't hear any hissing of any sort when everything is synched down.
As soon as I hit the trigger I get air mixed with water.
I also tried the system with out the hose attached, only the release valve.
After pressurizing, no hissing, I open up the valve and sputtering persists.
Should the down tube have an air tight fit with in the threaded nut that runs from inside the tank to the outside?
(hope that made sense)
I have tried an extra o-ring in-between the locking nut and the extension piece.
Looking at pictures online Im noticing different hardware in this area.
Thanks,
Jason
After a couple trips my Zodi hot shower is sputtering.
I have a trigger faucet modded to the hose. Everything worked great till the end of the last trip when the sputtering began.
I replaced a damaged o-ring that was located on the inside of the tank, and still had the sputtering.
I don't hear any hissing of any sort when everything is synched down.
As soon as I hit the trigger I get air mixed with water.
I also tried the system with out the hose attached, only the release valve.
After pressurizing, no hissing, I open up the valve and sputtering persists.
Should the down tube have an air tight fit with in the threaded nut that runs from inside the tank to the outside?
(hope that made sense)
I have tried an extra o-ring in-between the locking nut and the extension piece.
Looking at pictures online Im noticing different hardware in this area.
Thanks,
Jason
Last edited: