Antmax26's M762 Offroad Trailer Build for motorcycle

[antmax26]

I decided to try out some 3M anti slip tape on the floor of the trailer. I used the large step size and a roll. The smaller pieces were easy to trim into place and the large pieces have a small reflective strip.

 

[antmax26]

Hitch receiver

I decided to add a hitch receiver on the rear just like I did on my M416. Was actually very easy with the angle iron providing a sturdy base. I am not looking to use it for much more than a spare tire carrier.

 

[antmax26]

Jerry can mount

I added the same square tube in the front of the trailer that I had on the rear. I wanted to make some sort of bracket and holder to carry my Jerry can tool box, gas Jerry can, or scepter water cans. I took all of my plans to a local welder and this is what I came up with.

 

[antmax26]

Jerry can bracket

Here are the pictures of my almost finished mount. The Jerry can mounts nice and tight but I will need to modify the top mount if I want to use a Scepter can.

 

[antmax26]

Finished making the other side jerrycan holder. One note is that with the different jerrycans out there the bracket I made was made for each can individually. If I did it again I would make it with a lockable latch so I could adjust to any can.