What did you do to your Mitsubishi today?

[Inyo_man]

Replaced both broken, front engine mounts!

 

[Marutuk]

Checkout the following thread if you need help with the readiness monitors after you replace the ecu. Good luck!

http://www.expeditionportal.com/for...for-Montero-Owners-Who-Need-To-SMOG-Their-Car

Yeah that helped, and got an appointment with the referee on the 1st as there was no way to pass it atm.

Now it's also time to get my gen 3 fixed up as it's due smog as well, such as fixing the exhaust leak it has

 

[uncle]

Got my manual hubs installed.

Brian

 

[BOPOH]

Changed air filters in Montero and Lancer

20160903_113400 by Pavel B, on Flickr

20160903_113903 by Pavel B, on Flickr

 

[DSouth]

Changed front and rear axle oil
- Man the rear was dark brown/black, maybe original 170k mile fluid?
Changed transfer case oil
Changed Engine Oil + Filter
Found disconnected vacuum hose and re-connected.

 

[Clem]

Last weekend I used this

To get here

To do a little bit of this

For views like this

And this

Makin' memories

Hope you all had a good Labor Day, too!

Clem

P.S. Can't figure out how to make the pictures smaller, hmm.

 

[Outdooraholic]

I went from blown 16 year old factory suspension to an ARB OME 2" lift!

 

[Offroadmuch]

Got all fluids changed and upgraded to all-synthetic: engine, front and rear diff, transfer case. All Amsoil, local dealer nearby. Previous maintenance records are missing so I only know a little about work based on some investigative work. I know I have a new timing belt. The front diff oil was very clean when it was drained today so that was done but I am glad to know everything is new as of today. I will do the transmission flush and fill at a local shop that knows Monteros and will use 100% Mitsu transmission fluid.

 

[TheMole]

Got all fluids changed and upgraded to all-synthetic: engine, front and rear diff, transfer case. All Amsoil, local dealer nearby. Previous maintenance records are missing so I only know a little about work based on some investigative work. I know I have a new timing belt. The front diff oil was very clean when it was drained today so that was done but I am glad to know everything is new as of today. I will do the transmission flush and fill at a local shop that knows Monteros and will use 100% Mitsu transmission fluid.

Good stuff here. Mind sharing the name of the local shop that knows Monteros? Would like to bookmark it in case I need some work done.

 

[Offroadmuch]

The oil, diffs and trans case were done here:

Global on Newport Blvd.//Rochester in Costa Mesa, CA
The transmission will be done here:
http://www.ocoffroadandautorepair.com

 

[BOPOH]

Take a guess

Sent from my SAMSUNG-SM-G890A using Tapatalk

 

[EmersonHart13]

Changed the fluid both differentials, transfer case, and transmission along with a new filter too... Used SPIII too

 

[99Montero]

Waxed it and got update yesterday that my 3.15 T-case gears are almost done and I'll be shipped out soon! 😎

 

[miloe79]

Put in a new PCV valve, changed my oil to 10w30 and added Lucas stabilizer. Going to see if that slows down the oil consumption before looking into the valve stem seals.

So, any updates? Did the Lucas stabilizer worked, did it slowed down the oil consumption?

Sent from my SAMSUNG-SM-G870A using Tapatalk

 

[SD_Montero]

Driving from a job, going left at speed...35mph. Getting a kinda rhythmic slight thumping from the left side. I just did new front axles wheel bearings and rotors...and ball joints...any ideas what might be happening from anyone personal experience? Could I just be a bad cv joint?