SameGuy
Observer
I am in the very early concept stages of building a slide in camper for my Tundra. Mostly because there doesn't seem to be very many options out there as far as weight and of course cost are concerned. I would like to build a semi traditional looking cab over slide in camper framed and skinned with aluminum. I don't know how to weld but looking around there seem to be other options, mainly using blocks inside of the squaring aluminum tubing, then using bolts or screws to secure the blocks in place and into the adjoining connected pieces. Aluminum blocks that are pre threaded would make things easier but I was also considering some hard wood. Not sure if anyone has done this and not sure if there would be sufficient strength, especially for the cab over section. Any experience you could pass along would be greatly appreciated.