TheRedDawn
Observer
I posted a question regarding a re-skin of my camper and was asked to post some starting point pics.
I'm still looking into materials but wanted to share where I'm at, (which is basically the research phase).
I also put on a new roof, the new 1 piece for FWC. I'll post up these pics if I ever find the cord to my GF's camera. I'll be sticking with my iPhone for this project.
All around, lots of dents and dings mostly along the passenger side. When I replaced the roof, i had to brace a few broken and poorly re-enforced support bars that ran front to back. I'm a little nervous about what I might find under the skin. Not sure what is going on around the front passenger side jack and why the angle iron piece is/might be needed.
Here's the pics:
I'm still looking into materials but wanted to share where I'm at, (which is basically the research phase).
I also put on a new roof, the new 1 piece for FWC. I'll post up these pics if I ever find the cord to my GF's camera. I'll be sticking with my iPhone for this project.
All around, lots of dents and dings mostly along the passenger side. When I replaced the roof, i had to brace a few broken and poorly re-enforced support bars that ran front to back. I'm a little nervous about what I might find under the skin. Not sure what is going on around the front passenger side jack and why the angle iron piece is/might be needed.
Here's the pics:
Attachments
-
Back Left Jack.jpg282.9 KB · Views: 41
-
Back Right Jack.jpg220 KB · Views: 33
-
Front Right Floor.jpg270.6 KB · Views: 49
-
Front Right Jack.jpg219.3 KB · Views: 40
-
Front Window 1.jpg248.4 KB · Views: 39
-
Passenger side cabover.jpg178.5 KB · Views: 38
-
Side Window 2.jpg183 KB · Views: 33
-
Vents.jpg357.3 KB · Views: 34