I am building a cargo conversion trailer to take off road. I am in the process of changing out the axle and springs. I am using the factory leaf springs from the rear of my Tacoma and a 5200 Lb. axle to match the trucks bolt pattern and add brakes at the same time.
I want to use the same wheels as are on my 2010 Tacoma so that I only need one spare tire and wheel. Here is my question: do I need to run an adaptor in order to make the axel "hub centric"? The bolt pattern will be 6 on 5.5" so I can order the axel full width.
I am kind of concerned that the hole in the center of the adaptor might be too small to fit over the hub on the 5200 LB axle.