Adventurer
chaser trailer question's
I'm thinking about taking the plunge and buying one this fall but I have a few questions about the trailer , hopefully someone can answer for me.
I have all the dimensions on the site but I can't tell where the depth is measured. Say if you had the lid off what would the depth be to the top? Then what is the depth to the first bend? I'd like to use it without the lid at times.
Also what is the track width?
Thanks for the help!
Last edited by detailbarn; 07-30-2007 at 03:28 AM.
The main box is 26.28 inches top to bottomOriginally Posted by detailbarn
The lid is 6" deep
Outside of fender to outside fender 64"
Track width will vary with tire and rim selection, some fall a little outside the fender, some a little inside.
Adventurer
martyn thanks for the info, do you think it will be ok to use the trailer with out the lid? I want to mount a rack system to the lip right before the slope in the side , how tall is that little side without the lid. thanks again for you help.
Expedition Leader
Unless you travel in low/no dust areas I would recommend trying to figure out a way to utilize the lid...
1999 Toyota 100-Series Land Cruiser...not nearly stock
2009 Kimberly Sports RV 'King of the Offroad' trailer: Sadly gone but it sponsored some of the best memories of anything I've ever owned!
No problem using it without the lid, we design the lid so all you have to do is remove the center hinge, undo the gas struts, and slide the lid off.
The start of the first bend is 6" below the lip, 14" from the bottom of the box.
Martyn
Good point. The track and rack system we use on the Chaser is made by Thule. So anything you wanted to add inside the box could be added to the lid.
Posting Permissions
Reply With Quote