CB Installation Tips
i am getting ready to install my new CB (cobra 75 wx st/wilson lil' wil) and was planning on running the antenna cable to the rear so the mag mount can be placed on the back center of the roof. i think i am going to have the cable exit through a rear hatch grommet and splice in a quick disconnect so i can remove the antenna when not in use. since i will be tearing apart my interior front to back (not fun) i was thinking i would lay some 4ga cable for a future rear power distribution block...
is it potentially problematic to have power run parallel to my antenna cable?
any other general installation tips that might make this thread helpful to others?
'04 4.0L 4x4 Grand Cherokee - 4" spring/spacer lift, Bilstein 5150's, 255/70/16 BFG AT's, OME SD40, disco's, skids, hooks, sliders...and a new ECTED locker