Raszr
New member
I made a mount out of 1/2" plumbing pipe and assorted fittings. I used flanges to mount the bracket in three places along the tunnel and floor board to get the mount as close to the console as possible. I also used a union just above the console level so that when the mount does not have my pc I can remove the top section but leave the mounting in place. I then used foam and fabric to cover all the piping including the top section which is not in the photos. I think the hole enchilada cost my 50.00USD. But it is extremly rigid and secure. The laptop will be held in place with velcro straps but does not move.
Not sure about the AIRBAG possible issue... I think I will be toast. But you guys without airbags will be fine. Is there a way to deactivate the passenger side????
Raszr:arabia:
Not sure about the AIRBAG possible issue... I think I will be toast. But you guys without airbags will be fine. Is there a way to deactivate the passenger side????
Raszr:arabia: