Page 1 of 5 123 ... LastLast

Thread: 85 Chevy Flatbed

  1. #1
    Join Date
    Apr 2011
    Location
    Milwaukee, WI ... For now..
    Posts
    74

    Default 85 Chevy Flatbed

    I finally got rid of the Jimmy and found a nice replacement. On the way back from Madison (To Milwaukee, WI) it got me 25.33 MPG! I'm not sure how much of an Expo rig this will really be, besides a hauler and tow rig, seeing as it's 2WD, but I thought I might share it.

    What I know about it;

    - According to the owner it only has 85K on it. I'm not sure how much I believe that, but it's lack of rust rings some truth to that.
    - It's got a Jasper tranny and a shift kit that's a few years old.
    - It's glow-plugs are now manual (Which takes some getting used to)
    - Has an electronic pump

    And now, of course, everyone loves pictures.

    I'm thinking about replacing the grill with a later 80's-91 Suburban grille. A bit of nostalgia.
    IMG_20120702_085213.jpg

    Someone was proud of their 6.2
    IMG_20120703_174325.jpg

    Not much for the blue. There's someone trying to offload a brown Blazer with a 305 on Craigslist, might look for the brown interior there...
    IMG_20120703_174524.jpg

    The new seat would be great. I was wanting to just swap it out for a brown bench, but I might take the 2 buckets from that Blazer...
    IMG_20120703_174538.jpg

    Rust free, but dirty behind the seat.
    IMG_20120703_174550.jpg

    The roof of the cab is rust free and free of anything else but nice white paint.
    IMG_20120703_174602.jpg

    Electric pump.
    IMG_20120703_174658.jpg

    Flatbed. Steel frame with wood on top. Not quite sure what to do with it yet...
    IMG_20120703_174708.jpg

    Just a few hints from it's past.
    IMG_20120703_174615.jpg

    Someone liked it right away. (She also got real mad when we went inside the house.)
    IMG_20120703_173958.jpg

    Not nearly as bad as I was expecting for rust on a WI truck. I'm wondering what you all think can be done with it, seeing as most of you have multiple times more experience with trucks and have probably seen much more than I have. Nothing too extreme, as it will be my DD. And how useful do you think a 2WD truck can be?

    ~ Volk
    Looking for my next ride...

  2. #2
    Join Date
    Jul 2009
    Location
    Windsor CO
    Posts
    333
    My dad had a 2wd suburban with a 6.2 and when we were at the ranch he would tell me to not take a leak by the rear tires because we might get stuck



    I always liked dads burb but we didn't take it out when it was muddy

  3. #3
    Join Date
    Apr 2011
    Location
    Born in USA live in U.S.S.A.
    Posts
    588

    Smile Great lil flatbed

    The 6.2 is a trouble free diesel and that's a nice flatbed.

    I just the past week completed a resto for my daughter while not an expo type rig its an ole school 1984 c10 short-bed stepside,was a 6 banger with a three speed manual column shift now a chevy small block w/worked turbo 350 transmission and floor shifter, auburn posi w/3.08 gearset she loves it and actually gave up a Mazda Miata for it.
    1999 GMC K2500 BURBAN, NAVISTAR enhanced 6.5 td aftercooled, dual alt's, PSC p/s pump w/HD cooler, redundant FSD's, HEATH program, turbine/downpipe wrapped, 4" SS exhaust, real time OBD2 data logging w/device controller, EVANS waterless coolant @ zero (0) psi & 135 gpm pump, 4L80e w/kevlar and premium steel w/cryo treated input/output shafts running @ 100 deg. F & 140 deg F towing, all synthetic fluids, AMSOIL bypass system, MileMarker hydro, dual fuel tanks, and on and on, questions PM me.

  4. #4
    Join Date
    Jan 2009
    Location
    rock springs, wy
    Posts
    282
    thats a mr gasket fuel pump from o'rielly, they are not the greatest but cheap enough to carry a spare.
    http://wanderingwarringtons.blogspot.com/


    America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves.

    Abraham Lincoln

  5. #5
    Join Date
    Apr 2011
    Location
    Milwaukee, WI ... For now..
    Posts
    74
    Ah, good times with old Suburbans. I wonder if that was also because of the weight.

    Well, I've already had a few issues with it. Mostly all yesterday. (But I already had this all written up and was too tired to go into detail about what happened.)

    When I got to work yesterday my power steering and brakes went out when I got off the highway. After driving it to the parking lot at work (Felt like I was driving a big ol' deuce and a half.) it kicked back on as I pulled into my parking spot. After talking to a guy at work and I was done with my shift I headed to AutoZone to look for some new belts. (They both need to be replaced.) Came back out and, spent the next hour trying to start the truck. Finally gave up and walked home. Came back a few hours later and still nothing. It would crank, puff a little smoke, but wouldn't catch. I came back this morning and, behold, it started on the first try. No idea what's going on there, but it worries me as it's only been a few days since I got it.
    Looking for my next ride...

  6. #6
    Join Date
    Jun 2008
    Location
    Northern Utah
    Posts
    1,044
    Cool!

    The hard starts could be a number of things. For starters (lol) be careful not to crank the motor over for long periods of time. I believe the manual says something like 15 seconds with 1 minute to cool in between cranks Either way it doesn't take much to fry a 6.2 starter. Also holding the GP button for much longer than 10 or so seconds could burn out the plugs I would give them plenty of time to cool between cycles. Lots of people think "cycling" them multiple times before cranking helps with starting--it doesn't. The idea behind the electric pump is being able to prime the fuel system without having to crank the motor over. Its a good idea IF you have a high quality electric pump. I've been down that road a few times and in the long run I switched back to the manual block mounted (factory) pump because they seem to hold up better for me. If you choose electric make sure it is turning on and I would keep a spare and tools to change it on the road. 99 times out of 100 its the GP's or fuel delivery causing hard starts and luckily the 6.2's are simple to troubleshoot once you get familiar with them.

    Push button glow plugs are a good idea due to the fact if one or more plugs burn out the others will still work. Troubleshooting the system is much easier as well. I actually prefer this setup because your GP's don't have to cycle every time you start your truck.

    As for the 2WD you should be fine. I had a 2WD 82 GMC and it was constantly getting stuck in the snow but studded tires will help with a lot of that. Just carry some extra recovery gear and don't talk yourself into trails you know are a bad idea lol. Beyond that have fun I wouldn't let 2WD hold me back from having a good time
    91- F350 CC - 7.3-IDI IH diesel - ATS Turbocharger - ZF 5speed - 1981 Four Wheel Camper
    98- Toyota UZJ100 Land Cruiser - triple locked
    79- Toyota Hilux 20R 4x4.

    My Gypsy wagon buildup: http://expeditionportal.com/forum/sh...ad.php?t=38047

  7. #7
    Join Date
    Apr 2011
    Location
    Milwaukee, WI ... For now..
    Posts
    74
    Let the trouble shooting begin. Boy is it a doozy...

    So, I got in the truck after my shift, no troubles starting, and pulled off onto the road, then onto the highway to head home. I don't know the gear ratio in the truck, so I've been driving it at 55 mph. Not 5 minutes down the road and it starts to act a little funny. I looked at the gas gauge and noticed it had enough to go at least another 50 miles. Not 2 seconds after it sounds like the RPMs are going down, makes a few hollow sounding strokes, a "CLACK", then silence. By the time I stopped on the side of the road the only sound I could hear was the fuel pump. There was a little smoke at first, but it went away nearly before I got out of the truck. There was a trail of fluid from the road to where I stopped, and it was pooling and seeping off to the side. It was getting dark, and I had no flashlight, so I wasn't able to tell what color the fluid was or check if a rod had popped out anywhere. I had to leave it behind. Haven't even had it 4 days.

    Help?
    Looking for my next ride...

  8. #8
    Join Date
    Oct 2011
    Posts
    129
    Wow

  9. #9
    Join Date
    Feb 2010
    Location
    Los Angeles
    Posts
    644
    Quote Originally Posted by Zimnij Volk View Post
    Let the trouble shooting begin. Boy is it a doozy...

    So, I got in the truck after my shift, no troubles starting, and pulled off onto the road, then onto the highway to head home. I don't know the gear ratio in the truck, so I've been driving it at 55 mph. Not 5 minutes down the road and it starts to act a little funny. I looked at the gas gauge and noticed it had enough to go at least another 50 miles. Not 2 seconds after it sounds like the RPMs are going down, makes a few hollow sounding strokes, a "CLACK", then silence. By the time I stopped on the side of the road the only sound I could hear was the fuel pump. There was a little smoke at first, but it went away nearly before I got out of the truck. There was a trail of fluid from the road to where I stopped, and it was pooling and seeping off to the side. It was getting dark, and I had no flashlight, so I wasn't able to tell what color the fluid was or check if a rod had popped out anywhere. I had to leave it behind. Haven't even had it 4 days.

    Help?
    first thing will be to find out what was that fluid .atf? motor oil? dif oil? diesel fuel? 6.2 is super simple motor , if the motor died on u it must be diesel. and bad old fuel lines,

    also injection pump return hose put it clear one,so u can see if u eve get air in the system. glow plugs put 60G self timer in them. u cant burn them. electric fuel pump with check valve , and that's about it on 6.2 diesel.

    Eric
    Last edited by REDROVER; 07-06-2012 at 07:19 AM.
    1989 LAND ROVER
    LAND CRUISER COMING SOON
    http://www.youtube.com/watch?v=Yf9FPs40VUM

    GOD BLESS AMERICA

  10. #10
    Join Date
    Sep 2010
    Location
    Copenhagen and B.C.
    Posts
    1,256
    Jimmy, what can i say, ?Nice Truck! I say keep the flatbead and build a camper for it. The extra weight will give you good tracktion. Look at my sig if you need inspiration on building your own. Cheers Chilli.

Page 1 of 5 123 ... LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •