YETI Interior Build/Overview

[desertspeed]

The panels come with holes cut in them. The kit comes with Rivnuts, and they work quite well, as far as being able to remove the panel when you need access to the inside of the door. I have never used Dzus tabs, but I am sure you could call them up and they might be willing to do something different. Their staff is pretty helpful, one of the panels wasn't cut right, so they made me a new one, and sent it out right away. The kit also came with the Rivnut installation tool.

Rivnuts would work fine as well- I just want to be able to pull off the panel without drilling out rivets. On their website it looks like they use rivets, but maybe the pictures are too small to see the detail. Thanks

[pratty85]

I was concerned as well about having to drill out rivets to get inside the door, bc their pictures showed rivets. I had to request the rivnuts.

[ujoint]

It all looks great! Glad the project continues!

[desertspeed]

I was concerned as well about having to drill out rivets to get inside the door, bc their pictures showed rivets. I had to request the rivnuts.

Good to know- I need to replace the rear passenger door panel on mine anyways, so I will just use one of those with the storage and request it with the rivnuts. Thanks for the info!

[pratty85]

Thanks Chris!

[pratty85]

I got a decent amount of work done this afternoon. The cabin is fully insulated now, minus the doghouse. I didn't feel like tackling that dirty job tonight.

Hmm...something is missing?

Dynamat extreme installed


Insulation installed

New recliner is installed


I had to re-route the airbag sensor wire so it would reach and allow the seat to swivel


Tomorrow will bring more work, and more pictures!

[pratty85]

I thought I would post some pics of the down pipe clearance. If anyone was curious if a 4" down-pipe will fit, the answer is barely.

[bknudtsen]

Nice! Did the swivel base raise the seat height at all?

[pratty85]

Not enough to notice! I really like it, It will be great on those rainy days that me and my girlfriend are stuck inside. The sofa bed will be in between the wheel wells.

[pratty85]

I made a lot of progress today. I finished the insulation and started to put up the Adrain steel poly liner and found I needed longer screws. So that will wait til tomorrow. I also laid down the Adrian steel rubber mat.