Recent content by CactusJackSlade

  1. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    Yes, Sacramento, still on the pallet it shipped on :-)
  2. CactusJackSlade

    (SOLD) 2009 Ford E-350 EXT v10 4x4 Agile Quigley w/build out, 24" topper available

    WAY better, money WELL spent. The only trade off was about 2" higher lift (I don't prefer high vehicles)
  3. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    I am no longer considering this sale pending, the current interested party is 2000 miles away and reluctant to put down even a $100 deposit. SO.... first come first served. I'm Still interested in selling the mold as well (both for $2500)
  4. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    Luke D, thanks for the post up!.... Yes, if we had not gone the way of a Sprinter HighTop we'd be cutting the roof off our Ford right now! BTW, yours looks GREAT!
  5. CactusJackSlade

    Adventure Van Expo - Lake Tahoe, CA

    The Adventure Van Expo was a lot of fun and we saw way too many things we now need ;-) Just happen to pop up for a flight... can you count how many vans were there??! Lake Tahoe is always a draw for any type of event!
  6. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    Just responded to your PM... yes, if you are going to do it GO BIG.... should be good for 6'2" person, maybe more depending on floor and ceiling thickness.
  7. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    Here is an example of a 24" riser top on a nice Expedition van...
  8. CactusJackSlade

    24" fiberglass hi-top for late model ('92-'14) Ford Extended E Series van

    Sold my Quigley 4x4 Van and the buyer did not take the riser top... so it is for sale! They cost about $3300 absolutely bare bones to buy one here on the west coast. The one I have for sale looks very similar to these: http://fiberine.com/GVMR/24"_Bubble_Tops.html Attached photo is the actual...
  9. CactusJackSlade

    (SOLD) 2009 Ford E-350 EXT v10 4x4 Agile Quigley w/build out, 24" topper available

    Deposit taken, Sale Pending final funds transfer... I will miss my Ford!
  10. CactusJackSlade

    (SOLD) 2009 Ford E-350 EXT v10 4x4 Agile Quigley w/build out, 24" topper available

    The back bed area can be converted to two bench seats w/ small table (have the post, and floor post receiver installed but actual table top will be needed). You could use that area for work, however we used the "kitchen" counter area for work (laptop and our portable printer) with a small square...
  11. CactusJackSlade

    (SOLD) 2009 Ford E-350 EXT v10 4x4 Agile Quigley w/build out, 24" topper available

    Located in Sacramento, California Yes, I have a book of receipts and most of the original paperwork (dealer, Agile Offroad and Quigley) I am 3rd owner (2nd owner only had it 4 months before his divorce started and had to sell). 1st owner was a meticulous Fireman down in the L.A. area. VIN...
  12. CactusJackSlade

    24" fiberglass riser top for last gen Ford E Series vans (extended model)

    I do not have a photo of the bottom edge, but it is a straight edge, not a "lip". To install, as I understand it, is a molding piece that is like semi-flexible angle that rivets/screws into the top of the roof and then to the side of the topper. Sealed with RV adhesive/sealant. Apparently there...
Top