Not so much worried about the light itself. The tape fix is my plan B for ABS light and TPMS (I agree with ya there).
Since the engine light is now always on, I'm mostly worried about the computer only reading the ABS code and other possible issues going undiagnosed. So I'd like take the...
You lucky! Looks like 06 is the year Toyota decided to make things difficult and change a few things on 1st gen Tundras. The instrument cluster is totally different and I could figure out how to access the bulbs from the back. And access to the ABS fuse in the engine bay fuse box doesn‘t match...
Sound like we have a very similar rear axle. That is helpful thank you. I’m going to dig into it today.
What did you do for your speedometer and odometer? I just went with a gps unit since installing it matched my level of skill (or lack there of), but I’ve always wondered if there was a way...
We swapped in a rear Diamond Axle (full float, disc brakes) but no longer have the tone rings. This triggered the ABS codes and engine light. Don’t care too much about the ABS but definitely want the engine light functional.
If I pull the ABS fuse and clear the engine light codes will the ECU...
$300 for Set of 5
17x9, -24mm offset, 4.00” backspacing,
Toyota 6x5.5 bolt pattern
Used with minor rock rash on a few wheels
4 Center caps included
Lug nuts included
Located in Breckenridge, CO
Hey sorry for the delayed reply. I’m thinking a four step would work. My bumper is high clearance and even still I’ll often use leveling blocks to raise the steps some to make them flat. I think you could even remove the fourth step and go down to three if ya didn’t like it. Probably harder to...