Running the MPT 81 now. Not a daily driver but could be with a smaller truck… I measure 38.6 at 40 psi. Set my aev snap speedometer setting to that and right on compared to gps. Do it.
I don’t know the specifics on a 3500 but you will not have the wide front axle, you will have an 8 bolt wheel and a ton more aftermarket options. I may be wrong but if you want a singles, don’t get a 3500 dually and then run singles. Just get a 3500 SRW…. Going to a 45/5500 is the way I went but...
I would say 91” is minimum for ram. I’ve not seen dbl design or buckstop in person but looking at pictures of the wheel lip, they don’t tuck in any further than my narrow Stazworks setup.
Here was my 4500 with the 91 wide setup mounted. The 93” are strapped on the back.
There are only a handful of companies that build the conversion. I have first hand experience with both stazworks setups. They can do a square setup for ram 45/5500 where both front and rear match width at 93” wide. Obviously very positive offset in front, flip and very negative in back.
Or...
This problem is only going to get worse. Seems this one got a couple of us and tempted a few more. Red flags were raised. It took me 4 days of doubt, not wanting to slander someone, before it became clear enough to call out his other ads. We need to call the **************** without wrecking it for the...
As clearly not the expert… Others who have chimed in already listed the common tactics. The other posts with the “used” winch that was clearly new and the photoshopped hand which I didn’t pick up on the photoshop) were not posted at the time I bought. After I bought, he only referred to the...