Search results

Wish I would have known you needed a nv4500 socket. I could have sent you my custom made one.

Ford has some ideas on a winch for EV: https://fordauthority.com/2023/01/ford-patent-filed-for-ev-winch-and-winch-operating-method/

I built a 1989 Chevrolet V3500. Has Alcan leafsprings on all four and factory bench seat. Comfortable on the long highway rides and off road. I started with a RTT but built my own camper box with queen size bed up top and a couch/twin below.

Didn't have to remove anything. I had to grind a little off the front skid plate but I had an aftermarket steel skid plate.

I would be looking into upgrading your steering components also. Those factory tie rods are small. https://kryptoniteproducts.com/

I have two 80 watt panels on my hood for the past 2 years and it has worked great. I can leave my fridge running all week without starting my truck. The heat on the hood doesn't matter since you are not using solar when your rig is running.

I tried balance beads and I wasn't happy with them and ended up removing them (what a pain). I just took mine to a local 4x4 shop and they balanced them the old way and am happy. My beadlocks are DOT approved. But the shop would have done them either way.

I would check out 23ZERO and they are in your area. You can go to their show room and check it out. A hard shell will not work for that many people. With the 23ZERO and an annex will work for you for a lot of years.

I don't remember what @Everlanders did with his rear bumper. Are you going to make it an air tank? Truck looks great. Hopefully see it on the road in Oregon when you're done.

With you van being 2wd it isn't like you are going to driving trough a deep mud hole and since it will be mounted on the rear to get you out of something you pulled into not trough something so you should be able to get away with a smaller winch and carry a couple snatch blocks and a winch line...

Are these still available?

Learn how to take it easy and not have to have another electronic nanny.

Make sure you follow instructions. I bought a manufactured trailer and they installed a top and bottom plate so the panel had no where to expand when hot out and ended up popping the tape lose. Ended up screwing it all down.

I just read about it also. Trying to get it into the plans to attend.

Check out Element fire extinguishers: https://elementfire.com/

https://seattle.craigslist.org/see/cto/d/seattle-k5-blazer-with-four-wheel-camper/7142230373.html

This should be in the vehicle part section not expedition equipment.

Six of pieces of pipes. Set legs on pipe and roll. You might have to leave the one end on ground to change direction.

Wesspur. Tree climbing CO. They sell mill ends under "Specials" then clearance rope. Sent from my LG-V410 using Tapatalk

I have thought about same thing for my '91 square body. I have not done much research yet but was looking at riverraider.com? They have some brackets that might be useful. Sent from my LG-V410 using Tapatalk