Search results

@adam88 the Vehicle is stored in Ann Arbor Michigan. Interior height is 80” at the door and a few more than that on the inside area. My final design with insulation in floor and ceiling left a full width standing height of 6’4” Yes the van is AWD SRW.

Wheelbase is 156” compared to the 138” of the extended cargo van. It’s the same overall vehicle length just with less overhang behind the rear axle. I went with the longer wheelbase because I regularly drag hitch on the extended long wheelbase transit that I drive daily. I lived in a built out...

Adding more interior pictures

@jaho , Yes the van is still available. The box floor is 1-1/8" marine plywood with undercoating so it is very robust. the floor is supported by steel full width crossmembers which is what I would recommend that for attaching a seatbelt mount.

I bought this vehicle for my dream build out. It is spec'd with all the nice cab and drivability features. Audio upgrade, adaptive cruise, etc. Engine is the 3.5 NA with 10 speed transmission. Vehicle has a 12' Rockport cargoport box, selected for the high quality FRP wall construction, with...

Thanks Max for the shoutout! Robert, here is the link to the facebook posting with more pictures. https://www.facebook.com/marketplace/item/1024684214920759/ I will work toward getting some frame pictures but its pretty clean with just surface rust. the floorboards are fiberglass and springs...

Wyoming Minnesota,55092

My rig might be a little small for your goals. Have not installed the 4x4 but designed around it. https://expeditionportal.com/forum/threads/e350-with-7-3-cutaway-cube-4-season-camper-van-for-35k-obo.229731/

Had a few questions about the interior layout. here is a walkthrough video through the inside of the build.

2000 ford E350 super duty cutaway chassis with 'Mobile concepts' fiberglass two piece shell converted into a 4 season camper van that I built and have lived in for the last 3 years. I built this rig to facilitate my passion for outdoor sports while also enabling me to advance my engineering...

sold for 5k.

Let me crawl under the rig and confirm but I believe it is the C6. I usually just cruise about 65 mph and it does great.

Here are some in process pictures of the build in process 6.5' width 8.5' length 5.5' height

Thanks Jdubucsd for the tip. I was also checking alternator for function and it was not charging. Replacing it tomorrow and Hopefully that will solve the problem! I will add some pictures of the interior soon. Currently it is bare aluminum frame with insulation. If the rig doesn't sell I will...

I am looking to sell my project ambulance. I do not have adequate time or location to work on it as I intended unfortunately. Vehicle: 1986 F350 4x4 Front axle: Dana 60 with manual locking hubs Rear axle: Sterling 10.25 rear axle. Transfer case: NP 208 with high and low range Engine: Ford...