Search results

  1. K

    Fuso won’t start cold temps

    Its the pressure limiting valve on the end of the common rail, right next to the common rail pressure sensor. I have ordered one from Bosch for a 5.9 cummins, the valve opens at a similar pressure. Thanks
  2. K

    Fuso won’t start cold temps

    Bosch can only work off Mitsubishi part numbers, thus the whole assembly,
  3. K

    Fuso won’t start cold temps

    Finally figured this out Pressure relief valve on end of common rail was letting fuel by when cold Dealer and junkyard only sell this part as a whole rail assembly, anyone know a Bosch equivalent or where the part only can be purchased Whole rail is $1000 Thanks
  4. K

    Egr cooler/temperature gauge

    Gauge finally indicated cooler temperatures Guessing gauge is faulty and not indicating true temperature and dummy light is correct Egr recall involved new cooler and plumbing Guessing lines are installed incorrectly and not allowing coolant to flow through cooler
  5. K

    Egr cooler/temperature gauge

    Had my 2007 fuso fg into the shop for some work, was told that there was a recall bulletin for the egr cooler. Had egr work done and now I have a dummy light on the dash indicating the truck is overheating, but the temperature gauge indicates everything is good. But, temperature gauge...
  6. K

    Fuso won’t start cold temps

    Thanks skifreak Will start checking these tomorrow
  7. K

    Fuso won’t start cold temps

    I was using the code flash system incorrect and do have several codes. They are 12,14,15,25,33,36,89 and 95. Do not have manual with me. Anyone know what these codes are or a website where I can look them up? Thanks
  8. K

    Fuso won’t start cold temps

    Dirt whiskey The scanner is mut3, I’m starting to look into them This problem might have to wait, turning into a shop project, not a side of the road project Appreciate the advice
  9. K

    Fuso won’t start cold temps

    Nater When warm, above 40 or plugged in the truck starts within a second of engaging starter No drag on the starter at colder temperatures Cycling glow plugs several times has no effect Took it to Arizona recently, so went through 90 or so gallons Thanks
  10. K

    Fuso won’t start cold temps

    Fuel filter has less than a thousand miles on it Truck only has 15000 miles on it, so haven’t considered injectors I feel that 25/30 degrees shouldn’t cause any issues with fuel. Never had problems with my other trucks with temperatures significantly colder I have a block heater on it which is...
  11. K

    Fuso won’t start cold temps

    Natersxjx I pulled the plugs out and checked resistance on each one, all were within spec I felt the glow plug duration is also short, but could not find info in the manual on this I believe voltage drop to +or - nine volts is normal on the glow plug circuit Thanks
  12. K

    Fuso won’t start cold temps

    2007 fuso fg 140 When I purchased would not start in cool temps( 40 f and below). Replaced faulty water temp sensor. Now starts down to 25/30 f. Batteries are charged Glow plugs are within spec Relay works fine Glow plugs receiving 8/9 volts for eight seconds. Glow plug indicator on dash is...
  13. K

    suspension suggestions

    Alanymarce I am not interested in increasing load. The fronts are sagged and the vehicle lists to the passenger side. Would like to have it ride level and be more than a 1/2" to 3/4" off the stops. Supervan I have had previous projects with Alcan that didn't go as planned Had some good...
  14. K

    suspension suggestions

    I wanted to have a way to get in without having a ladder or steps. Did not want to relocate fuel tank. I can't see any difference between a door on this side and getting out of the drivers seat.
  15. K

    suspension suggestions

    Getting near end of project and looking for suspension suggestions. I'm located in Colorado, US. Obvious answer would be Alcan, will not be going that route. Any suggestions? Thanks
Top