Search results

I've got a Neon popup and I'd like to be able to recharge the battery in the trailer from the vehicle as I drive. I have a 7 pin trailer connector that came with the towing package. It has 12v on pin 4, but looking at the wire feeding that pin its 12 or 14 gauge wire. That's enough to run the...

Anyone tried this kind of setup on thier expedition trailer? The basics of the design as far as I've been able to gather is a longer softer set of leaf springs with airbags directly over the axle. I think this setup is used by OTR trailers. Might be simplier to set up and easier to maintain...

I'm Considering getting a used JT1000, Anyone have any experience good or bad? KC9ULJ

I'm planning on programming it for GMRS freq's (I'm licensed). Anyone have suggestions for layout? SG120 has 16 programmable channels, can program PL, narrowband, 40W output. I'm thinking 1-7 would be the 7 Interstitial channels and 8-15 the 8 GRMS only channels with 16 for my home channel and...

CBS, Sunday Morning had a short almanac story this morning on the 69th anniversary of the roll out of the Jeep. Happy birthday Jeep! :JEEPIN:

Weak link? what weak link...

Just wanted to share this. I used a 12"x12" 1/8" viton sheet stock tacked sheet stock to a piece of plywood. used a 3 1/2 inch holes saw to mark center and edge. did not go all the way through. used a 2 inch hole saw to cut out the center finished cutting the outside with 3 1/2 inch hole...