HazVan - 2002 E-350 SuperDuty 7.3l PSD

turbodiesel

Active member
Needed to convert 2004 F250 speed sensor to 2002 E350. They both had the male ends. Cutting and reattaching was an option, but decided to make an adapter out of SKS1021 ABS wheel speed sensor ends.


 
Last edited:

turbodiesel

Active member
If anyone needs a good frontend/rear for a E350, pm me. Both axles plus wheels and tires will be for sale. (Cooper Discoverer A/T All-Season LT245/75R16 & brakes/rotors with less than 5K on them)
 

turbodiesel

Active member
Poor photos, but got the shackle flip installed! Once the axle in, we'll see what that gets me in lift. Has to cut the exhaust, I'll weld it back over the leaf springs likely. Need to see where the wheel and tires sit. Might just go straight out the back.
 

turbodiesel

Active member
Time for the transfer case to get mounted up. Original plan was transmission swap, but got a BW 1356 w/ Quigley adapter which saves me from a full transmission swap. (Thanks Jake!)

IMG_20211018_181412358_HDR.jpg
 

turbodiesel

Active member
Relocated the spring perches. Tack welded for now. I'll check the angles once I get the transfer case mounted up. Hopefully I get lucky and they are within a degree.
 

turbodiesel

Active member
Axles are in, wheels are on. It's getting closer and with the wheels on a bit safer to shift weigh around. On to dropping the tank and install the BW1356 tcase w/ Quigley adapter.
 
Top